REMEMBER!
To leave the Programming
Mode at any time, press the
Esc
key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 15:
Computer
Trouble Delay
If either [FBI] or [ADEMCO] receiver emulation was selected in
PARAMETER 02,
there is no need to program this parameter, and its
default [48] should be accepted.
Programming Procedures:
When
PARAMETER 12
is entered, [HEADER 48] (corresponding to the
ASCII
[H]) will be displayed, and the [4] will be flashing. Any
ASCII
value
between [00] and [FF] may be programmed by using the
NEXT
key or the
MANUAL/PREVIOUS
key to change the first character, as required.
Once this is done, use the
key to move to the second character and, as
before, use either the
NEXT
key or the
MANUAL/PREVIOUS
key to change
it, if necessary. Subsequent movement between the two digits can be
accomplished through the use of the
key or the
key.
Default
:
The character [H] corresponding to
ASCII
[48] is the default.
Advancing to Next Parameter:
After programming
PARAMETER 12,
press the
N
key to advance to
PARAMETER 15
– the next parameter in
Category C
.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 12]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
•
1
then
5
, or
• then
key and
5
, or
• the
key
NOTE: When the
is used, the
name
of the next parameter appears
immediately – not its
number.
TROUBLE DELAY 05 SEC MM/DD/YY HH:MM:SS
Background:
If an
Automation System
is present (and has been accounted for in
PARAMETER 00
), the CP-220A will continually monitor its presence and
status, and will display [COMPUTER FAIL] in the event of a computer
failure.
PARAMETER 15
determines how long the CP-220A should wait
with the computer "in failure" before it displays this message.
CP-220A Central Station Receiver
Section 2: Programming the CP-220A Page 2-81
Hook-Up and Installation Manual
