REMEMBER!
To leave the Programming
Mode at any time, press the
Esc
key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 52:
XOFF
MANUAL/PREVIOUS
key to change the first character, as required. Once
this is done, use the
key to move to the second character. As before, use
either the
NEXT
key or the
MANUAL/PREVIOUS
key to change it, if
necessary. Subsequent movement between the two digits can be
accomplished through the use of the
key or the
key.
NOTE: The
Automation System
must support the
XON/XOFF
"handshaking" technique, or the default of [00] must be
programmed.
Default:
PARAMETER 51
is defaulted to [XON 00].
Advancing to Next Parameter
After programming
PARAMETER 51,
press the
N
key to advance to
PARAMETER 52
– the next parameter in
Category C
.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 51]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
•
5
then
2
, or
• then
key and
2
, or
• the
key
NOTE: When the
is used, the
name
of the next parameter appears
immediately – not its
number.
XOFF 00 MM/DD/YY HH:MM:SS
Background:
PARAMETER 52
goes hand-in-hand with
PARAMETER 51.
For
background information, read
PARAMETER 51
on page 2-97 before
programming this parameter.
Programming Procedures:
After entering
PARAMETER 52,
[XOFF 00] will be displayed
,
with the first
[0] after [XOFF] flashing. Although it's customary to use
ASCII
[19] for
XOFF
, any value between [01] and [FF] may be programmed. Use the
NEXT
key or the
MANUAL/PREVIOUS
key to change the first character, as
required. Once this is done, use the
key to move to the second character.
As before, use either the
NEXT
key or the
MANUAL/PREVIOUS
key to
change it, if necessary. Subsequent movement between the two digits can
be accomplished through the use of the
key or the
key.
Page 2-98 Section 2: Programming the CP-220A CP-220A Central Station Receiver
Hook-Up and Installation Manual
