Hioki IM3536, Instruction Manual

Page: 52 / 270

48
Setting Measurement Conditions (basic settings)
Judgment synchronization setting
When the JUDGE SYNC setting is turned on, the instrument will select the optimal range automati -
cally based on the comparator measurement or BIN measurement judgment standard. (See "Judg -
ing Measurement Results" (p. 69).)
This setting is useful when performing comparator measurement or BIN measurement of a variety
of impedance samples, including samples whose impedance varies greatly with frequency.
Screen display method (For more information, see p. 24.):
AC measurement: (Measurement screen) SET key>( SET screen) BASIC tab> RANGE key
DC measurement: (Measurement screen) SET key>( SET screen) Rdc tab> RANGE key
(Example: Comparator)
1
Touch the JUDGE SYNC ON key.
2
Touch the EXIT key twice.
Displays the measurement screen.
•This setting is only available when the judgment
standards have been set for comparator and BIN
measurement
• When the comparator and BIN measurement
judgment standards have been set with this set-
ting enabled, the instrument will automatically
switch to the optimal range. If no judgment stan -
dard has been set, the instrument will function
the same as when the AUTO setting is enabled.
• If only the θ , D, or Q measurement parameter
has been set, the instrument will function the
same as when the AUTO setting is enabled.
• During AC measurement, because the phase
angle cannot be calculated for some combina -
tions of parameters, the range is determined
from ideal values. For more information, see the
table below.
(See also "Appx. 1 Measurement Parameters
and Calculation Formula" (p. Appx.1)).
• Set the range based on the maximum value for
the comparator measurement or BIN measure -
ment judgment standard. Depending on the judg-
ment standard setting, measured values may fall
outside the guaranteed accuracy range.
Parameter combination conditions for the judgment synchronization setting
You may be unable to enable the JUDGE SYNC setting for certain combinations of No. 1 and No. 3
parameters.
(1) AC measurement
No. 3 parameter
No. 1 parameter
AC OFF Z Y Rs Rp X G B Ls Lp Cs Cp θ D Q σ ε
OFF × ● ●
        
× × × × ×
Z ● ● ●
        
● ● ●
 
Y ● ● ●
        
● ● ●
 
Rs
           
● ● ●
 
Rp
           
● ● ●
 
X
           
● ● ●
 
G
           
● ● ●
 
B
           
● ● ●
 
Ls
           
● ● ●
 
Lp
           
● ● ●
 
Cs
           
● ● ●
 
Cp
           
● ● ●
 
θ × ● ● ● ● ● ● ● ● ● ● ● × × × × ×
D × ● ● ● ● ● ● ● ● ● ● ● × × × × ×
Q × ● ● ● ● ● ● ● ● ● ● ● × × × × ×
σ
×
          
× × × × ×
ε ×
          
× × × × ×
×: Invalid setting (Same operation as AUTO setting),

: Set from ideal value since phase angle cannot be calculated.,

: Configurable