Hioki IM3536, Instruction Manual

Page: 11 / 270

7
Measurement process
7
Set the first parameter to Cs and the third parameter to D. (p. 39)
Example: Set the first parameter to Cs
1
3
2
When you wish to perform DC in addition to AC measurement, set the parameter to Rdc .: “To per -
form DC measurement (DC resistance measurement)” (p. 40)
8
Set the measurement conditions.
Press the
SET
key, select the
BASIC
tab, and configure the settings as desired. (The numbers under -
neath the buttons indicate the default settings.)
1
3
2
FREQ Measurement frequency: 1.0000 kHz
(p. 44)
(Required: configure based on the
measurement sample.)
AVG Average: OFF (p. 57)
(Optional: Set to ON when you wish to
prevent instability in the display value.)
RANGE Measurement range: AUTO (p. 45)
(Required: configure based on the
measurement sample.)
DC BIAS DC bias: OFF (p. 60)
(Optional: Set to ON when you wish
to superimpose the DC voltage on the
measurement signal during capaci-
tance measurement.)
LEVEL Measurement signal mode:
Open circuit voltage (V) mode
Measurement signal level: 1.000 V
(p. 49)
(Required: configure based on the
measurement sample.)
DELAY Trigger delay: 0.0000 s (p. 64)
(Optional: If the trigger synchronous
output function is enabled, set to a
large enough value that measurement
can stabilize.)
SPEED Measurement speed: MED (p. 55)
( Optional: Change this setting when
you wish to perform measurement
more quickly or at a higher level of
precision.)
TRIG Trigger: INT (p. 63)
(Optional: Set to EXT when you wish to
input the trigger manually, using EXT I/O,
or using the interface.)
LIMIT Voltage and current limit
: OFF
(p. 59)
(Optional: Set to ON when you wish
to limit the voltage or current that is
applied to the sample.)
SYNC Trigger synchronous output function:
OFF (p. 65)
(Optional: Change the setting when
you wish to apply the signal to the
sample during measurement only.)
10
9
8
7
6
5
4
3
2
1