4.14 Hilow Crank Rod and Drive Screw Assembly Including Gas Springs (Manual Model Only)
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 32
Basic Care™ Bed Service Manual (man336)
4.14 Hilow Crank Rod and Drive Screw Assembly Including Gas
Springs (Manual Model Only)
Tools required:
Small screwdriver
17 mm wrench
17 mm socket
Ratchet
10 mm Allen™
1
wrench
13 mm socket
Removal
WARNING:
Do not work under an unsupported load. Install appropriate temporary
supports. Failure to do so could result in personal injury or equipment
damage.
1. Put bed supports under the upper bed frame.
2. Raise the knee section and the head section to their highest positions.
3. Lift the foot section of the sleep surface, and fold it back toward the head
section.
NOTE:
If either of these sections cannot be raised, this procedure can be done from
underneath the foot end.
WARNING:
Attach the foot section to the head section. Failure to do so could result
in personal injury.
4. Use straps to attach the foot section to the head section.
5. Remove the footboard (A) from the bed frame (B) (see figure 4-14 on page
6. Remove the plastic housing (C) from the crank handle assembly (D).
1. Allen™ is a trademark of Industrial Fasteners, Inc.
