MAN3184 - TITANUS PRO
•
SENS®
120
6.7 Electrical connection
The following steps must be initially performed to prepare the electrical
connections:
► Break through the necessary number of cable glands (e.g. with a
screwdriver).
► Insert the M20/M25 membrane cable entries (device accessories kit)
into the corresponding cable glands.
► Feed the cables through the corresponding cable entries.
The electrical connection is made via terminal strips X6
– X7 on the
TITANUS PRO·SENS® basic board. Observe the permissible cable
diameters of the cable entries and the permissible wire cross-sections of the
terminals (max. 1.5 mm² wires).
The device comes with one M20 and two M25 membrane cable entries.
NOTICE
Perform all connection work with the device disconnected from the mains.
ATTENTION
In order to maximise fault protection, use shielded cables for the external
cabling of the device.
NOTICE
Summary of Contents for Ampac TITANUS PRO-SENS
Page 51: ...MAN3184 TITANUS PRO SENS 51 Figure 34 Pipe shapes...
Page 61: ...MAN3184 TITANUS PRO SENS 61 Figure 36 Example pipe project planning with pipe accessories...
Page 118: ...MAN3184 TITANUS PRO SENS 118 Figure 73 Drill hole intervals for bracket type MT 1 mm...
Page 135: ...MAN3184 TITANUS PRO SENS 135 Figure 84 Attaching the aspiration reducing film sheet...