Halma Ampac TITANUS PRO-SENS, Technical Manual

Page: 129 / 197

MAN3184 - TITANUS PRO • SENS®
129
7.1.1 Installing the pipe system
The pipe system must be installed according to project specifications and
taking into account the project planning guidelines (see chapter "Project
planning").
► Cut the pipes with a pipe cutter or a metal saw. Deburr the cut edges
and remove any shavings.
► Rid the bonding surfaces of dirt and grease with the stipulated cleaning
agent before gluing. Then, glue the pipe joints so they are airtight with
the fittings.
Aspiration pipe
halogen-free
Aspiration pipe
(UPVC)
Cleaner Adhesive Pipe cutter
ABSR-2518 R-2519 Tangit cleaner Tangit glue Pipe shears or
ABSR-3220 R-3218 cutter (38 mm)
ABSR-4025 R-4019
► Minimise the pipe lengths and changes of direction. Angles have
extremely high flow resistance. Therefore, they are only to be used
where they cannot be avoided due to structural constraints. If necessary,
the pipe length must be reduced in relation to the angles used (an angle
corresponds to a straight pipe length of 1.5 m).
► Mount the pipe system firmly so that it will neither bend nor become
distorted. Fasten the pipe with pipe clips without rubber inserts. The
intervals between the pipe clips should not exceed 80 cm. In case of
high temperature fluctuations, reduce the intervals between the pipe
clips to maximum 30 cm.
Adhesives and cleaning products contain solvents and are flammable. The
safety notes of the supplier must be observed prior to use.
ATTENTION
Elbows are to be given absolute priority over angles. Too many angles and
elbows reduce the air speed in the aspiration pipe and thus increase the
detection period.
NOTICE