SECTION 3 –
CAB
3-40
Drive Fault
The third drive state, “Drive Fault” may
appear as a warning message on the display
page if there is a system malfunction that
affects the machine’s ability to function
properly. This message will tell you why the
error occurred and what, if anything, should
be done to correct the issue. As a result,
machine performance will be limited.
NOTE: When a Drive Fault is present, the
Field/Road Button (located on the
Home Page) will be replaced by
“FAULT”. Settings will be in Field
Mode.
Speedometer
The speed in which the machine travels is
displayed on the Home Page - Road and
Field Mode. The unit of measure can be
viewed as miles per hour (mph) or kilometers
per hour (km/h).
NOTE: See “Display Units/Animations/
Gauge Color/Language” for
information on changing the unit of
measure.
Target Speed
NOTE: Machine speed is limited to 20 mph
(32 km/h) when the solution tank
level exceeds the transport limit.
Refer to “Specifications” provided in
the Introduction Section elsewhere in
this manual for transport limit on your
machine.
The Target Speed (displayed on the
Home Page - Road and Field Mode) is the
speed in which the machine travels when the
Hydrostatic Drive Control Handle is in the
fully FORWARD position and the Decel
Pedal is NOT pressed.
To Change Target Speed
•
Press the Adjust Button (located on the
Settings Page) for desired field or road
speed setting.
•
On the “Speed Settings” screen, evenly
space target speeds as desired using
the Up/Down Buttons for each setting
(First Range Top Speed, Last Range
Top Speed, and Number of Ranges).
Speedometer
(Located on the Home Page
- Road or Field Mode)
Target Speed
(Located on the Home
Page - Road and Field Mode)
Adjust Buttons - Field/Road Speed Settings
(Located on the Settings Page)
