SECTION 9 –
MAINTENANCE AND STORAGE
9-12
right-hand side of inside scoop) and set
aside.
•
Remove Engine Scoop from mounts and
set aside.
•
Remove the two (2) Radiator Screen
Spring Clips (located on the top left and
right-hand side of screen) and set aside.
•
Extend the top of Radiator Screen out-
ward and lift the bottom of screen out of
lower pin cradles.
To Reinstall the Radiator Screen
•
At a slight angle, install the lower screen
pins into the pin cradles (located near
the bottom of the cooling pack), as
shown in the following illustration.
•
Rotate screen inward until the mounting
pins protrude through the screen.
•
Reinstall the two (2) Radiator Screen
Spring Clips.
•
Reinstall Engine Scoop and Engine
Scoop Spring Clips.
Cleaning the Radiator Screen
Use compressed air to dislodge large
debris and dirt. Water from a pressurized
hose may also be used or if necessary, the
screen may be soaked with soapy water and
scrubbed gently with a brush.
NOTE: When cleaning the cooling fins of the
radiator, oil cleaner, or A/C
condenser with compressed air or
water, be careful not to damage the
cooling fins, which may impair
cooling capabilities.
Engine Oil Filter
The Engine Oil Filter (located on rear left-
hand side of machine below hydraulic oil
reservoir) should be replaced every 500
hours of operation or whenever the oil is
changed, whichever occurs first.
Engine Scoop Spring Clips
(Located on the top left and
right-hand side of inside scoop)
-Typical View
Radiator Screen Spring Clips (2)
(Located on the top left and
right-hand side of screen)
-Typical View
-Typical View