10-31
SECTION 10 –
MISCELLANEOUS
9. Once proper distance is achieved, hand-
tighten top and bottom Anchor Bolts on
each side.
10. Using a tape measure, ensure the dis-
tance from the outer edge of the right
and left-hand cross member support
tube to the inner edge of the hanger pin
(of the center Brush Guard Rail) is 24”
(61 cm), as shown in the following photo.
NOTE: If needed, use a rubber mallet to
obtain proper distance.
11. Repeat Step 15 on opposite side, ensur-
ing 24” (61 cm) distance.
12. Once proper distance is achieved, hand-
tighten top and bottom Anchor Bolts of
each center Brush Guard Rail.
13. Starting at the bottom, install Brush
Guard Tubes to Brush Guard Rails,
securing with U-Bolts and tightening with
a 1/2” wrench.
NOTE: Ensure U-Bolts are not over-
tightened. If the bolts are snugged
too tight, the brush guard extensions
will not extend properly.
NOTE: Ensure the Brush Guard Adjustment
Clips located on each end of tube are
facing upward when installing.
-Typical View
-Typical View
-Typical View
-Typical View
