9-15
SECTION 9 –
MAINTENANCE AND STORAGE
3. Remove and discard used Pressure Fil-
ter.
4. Install new Pressure Filter.
5. Reinstall Pressure Filter Housing and
metal shield.
Charge Pump Filter
1. Ensure the engine is shut OFF.
2. Hold the Charge Pump Filter (located
beneath the drive pump) in place and
remove filter from housing using a 24mm
wrench.
3. Remove and discard used Charge Pump
Filter.
NOTE: Inspect the plug and seal surfaces in
the filter bracket. Replace any
damaged components.
4. Lubricate the seal and o-ring with
hydraulic fluid.
5. Insert plug into filter bracket.
6. Using a 24mm wrench to hold the plug in
place, install new Charge Pump Filter.
NOTE: Hand-tighten filter until it makes
contact with the o-ring, then tighten
half a turn further.
7. Turn the engine ON.
8. Cycle the pump through normal machine
operation and check for leaks.
Case Drain Filters (2)
1. Using a 2
1/4
” wrench, loosen Case
Drain Hose (located near top of hydraulic
oil reservoir) to prevent siphoning when
changing the Case Drain Filters.
2. Turn desired Case Drain Filter (1 or 2) in
the “counter-clockwise” position to
loosen.
Pressure Filter Housing
(Located beneath right-hand side of
machine - lower metal shield to access)
-Typical View
Charge Pump Filter
(Located beneath drive pump)
-Typical View
Case Drain Hose
(Located near top of hydraulic oil reservoir)
-Typical View
