5-7
SECTION 5 –
HYDRAULIC SYSTEMS
Hydraulic Manual Tread Adjust
1. Engage the parking brake.
2. Start the engine.
3. Press the Field/Road Button (located on
the Machine Display Home Page) and
change the machine’s drive state to
FIELD.
NOTE: The drive state of the machine
cannot be changed unless the
Hydrostatic Drive Control Handle is
in the NEUTRAL position (and
machine speed is less than 0.5 mph/
0.8 km/h).
NOTE: The selected drive state will
illuminate.
4. Press the Manual Button (located on the
Machine Display Auxiliary Controls
Page).
5. On the Tread Adjustment Screen, select
the tread that you wish to adjust by
pressing the desired “wheel(s)” on the
display screen.
NOTE: Tread width may be adjusted
individually or simultaneously.
6. With the machine moving in forward or
reverse - at speeds up to 10 mph
(16 km/h), press and hold the In or Out
Button until desired tread width is
achieved.
NOTICE
The machine’s drive state must be in
FIELD MODE before adjusting tread
width.
NOTICE
Tread Adjust is disabled when traveling
at speeds above 10 mph (16 km/h).
Field/Road Button
(Located on the Machine Display
Home Page)
Manual Button
(Located on the Machine Display
Auxiliary Controls Page)
Tread Adjustment Screen