SECTION 10 –
MISCELLANEOUS
10-32
14. Repeat process for remaining brush
guards.
Brush Guard Extension
•
Remove adjustment clip from pin
(located on the end of each brush guard
tube).
•
Extend tube to desired position, ensuring
hole openings align.
•
Reinstall adjustment clip to pin.
Installing Front Shield
1. Pre-assemble support hook and bolts to
the Front Shield (one side only) and
hand-tighten with a 1/2” wrench.
2. Install support hook into the correspond-
ing hinge bushing (located beneath the
front end of machine near tread adjust
bolts).
3. Install support hook into hinge bushing
on opposite side of machine (without
bolts and nuts).
4. Lift Front Shield and install bolts through
back side of panel and support hook.
Hand-tighten with a 1/2” wrench.
Brush Guard Tube
-Typical View
• U-Bolts
• Adjustment
Clip
Brush Guard Installation
-Typical View
Brush Guard Adjustment Clip
(Located on the end of each tube)
-Typical View
-Typical View
• Hinge
Bushing
• Support
Hook
