5-9
SECTION 5 –
HYDRAULIC SYSTEMS
4. Press the Auto Button (located on the
Machine Display Auxiliary Controls
Page).
5. On the Auto Screen, press EDIT (next to
desired front or rear tread width setting).
6. Enter new value (distance of extended
cylinder), then press OK.
NOTE: Tread width values are based off of
travel distance.
NOTE: Front and rear axles may be set
separately if desired.
7. Press the Auto Align Button (located on
the Auto Screen) to begin sensor align-
ment.
NOTE: The display will show “Pending” until
machine speed is above 0 and less
then 10 mph (16 km/h) and Field
Mode is active. Once desired
distance is achieved, the display will
show “Completed” and tread valves
will not activate.
Tread Calibration
Tread Calibration may be performed
during initial setup, if a tread sensor has been
replaced, or if tread is not traveling to desired
programmed spacing.
Auto Button
(Located on the Machine Display
Auxiliary Controls Page)
Auto Screen
Input Screen
(Front tread shown)
Tread Adjust Sensor (4)
(Located on each leg)
-Typical View