GE Medical Systems marquette Dash 2000, Operator'S Manual, Page: 33 / 272

Revision C Dash 2000 Patient Monitor 1-13
2005873-001
Turning Power On
AC Power
Normal Mode
Standby Mode
The Dash 2000 monitor will be powered at all times when using AC power
(there is no AC power switch). The monitor is preset at the factory for a
specific AC voltage. Before applying power, be sure the power requirements
match your power supply. Refer to the label on the back of the unit for the
voltage and current requirements. Refer also to Power Requirements in the
Safety chapter of this manual.
When all cables are properly connected, press the POWER button to turn
the monitor on. After approximately 10 seconds you should see a display on
the screen. The AC indicator on the front panel will light when using AC
power.
Two modes of operation are available when using AC power. The monitor
will enter "NORMAL" mode when plugged into AC power and the monitor
is turned ON. Normal mode operation provides all functional capabilities of
the monitor including vital signs monitoring, communications, and battery
charging.
The monitor will enter "STANDBY" mode when plugged into AC power and
the monitor is turned OFF. The battery charging function is the only
function provided when the monitor is off.
AC Battery
Power
Graph Go/Stop
NBP Go/Stop
Function
Silence Alarm
Trim Knob
Charging Status
ECG
150/ 50
75
SPO
2
105/ 90
RT
70
* * *
97
NBP
200/ 80
ADT
X
X X/
AC power indicator
005
AC Power Indicator