GBC FusionPunch II, Service Manual

Page: 129 / 430

ADJ 5.2 Stacker Tray Stop Position
GBC FusionPunch II Service Manual
12/2003
4-33
ADJ 5.2 Stacker Tray Stop
Position
Purpose
To prevent excessive overtravel or undertravel
of the paper on the Stacker Tray.
Check
Check that the Stacker Tray stops 0.75 in. (19.0
mm) from the top of the Back Plate.
Adjust Sequence
1. Loosen the Locknut on the Stacker Upper
Switch Assembly (Figure 2).
2. To adjust the Stacker Tray Stop position,
turn the screw clockwise to decrease the
measured distance, or counterclockwise to
increase the measured distance (Figure 2).
3. Press "RAISE/LOWER STACKER#1" (or
# 2 if a second Stacker is installed and
needs to be adjusted) on the Control Panel
once to lower the Stacker Tray, and once
again to raise the Stacker Tray.
4. Recheck the adjustment.
5. Repeat steps 2 - 4, if necessary.
6. Tighten the Locknut on the Stacker Upper
Switch Assembly (Figure 2).
Figure 1.
Figure 2.
LOCK NUT SCREW
STACKER TRAY
0.75 in.
(19.0 mm)
BACK
PLATE