GBC FusionPunch II, Service Manual

Page: 117 / 430

REP 5.4 Bypass Gate Fingers
GBC FusionPunch II Service Manual
12/2003
4-21
REP 5.4 Bypass Gate Fingers
Parts List: 5.2 A
Prerequisite
Lower the Stacker Tray.
WARNING
Switch off the Main Power.
Disconnect the power cord.
Removal
1. Open the Stacker Top Cover and Front
Door.
2. Make marks on the Bypass Gate Shaft
(Figure 1).
3. Loosen:
3.1 the 7 Allen screws in the 7 Gate
Fingers.
3.2 the Allen screw in the Bearing Collar
(Figure 1).
NOTE: Ensure that the setscrews in
the Gate Fingers are loosened enough
to clear the round part of the shaft.
4. Remove the Bearing Collar.
5. Slide the Bypass Gate Shaft towards the
back of the machine until you can remove
the Gate Fingers (Figure 1).
Replacement
1. Reinstall the parts in the reverse order.
2. Perform ADJ 5.4 Bypass Gate Solenoid and Gate Fingers.
MARK THE
GATE SHAFT
BEARING
COLLAR
Figure 1.