GBC FusionPunch II, Service Manual

Page: 123 / 430

ADJ 4.2 Sheet Eject Solenoid
GBC FusionPunch II Service Manual
12/2003
4-27
ADJ 4.2 Sheet Eject Solenoid
Purpose
To prevent paper jams in the Punch.
Check
Check that cover stock and tab stock transports
through the Punch without a jam, or without
stalling.
NOTE: Ensure that the Side Guide
adjustment is not too tight (see Side
Guide Adjustment in the User Guide -
Chapter 2, General Procedures).
Adjust Sequence
1. With the Sheet Eject Idler Rollers in the up
position, check the distance between the
Idler Rollers and the Rubber Drive Rollers.
The distance should be approx. 3 - 4 mm.
2. To adjust, slightly loosen the 2 Allen Head
Cap screws and raise or lower the Sheet
Eject Idler Rollers until the distance is equal
between the back and front rollers.
3. Manually press the Sheet Eject Idler Rollers
down so that they touch the Rubber Drive
Rollers. Make sure that the Idler Rollers are
centered over the Rubber Drive Rollers.
4. To adjust, slightly loosen the 2 Allen Head
Cap screws and move the Sheet Eject Idler
Rollers forward or backward to center the
Idler Rollers over the Rubber Drive Rollers.
5. Check that the Sheet Eject Idler Rollers are
both centered over the Rubber Drive
Rollers and at the same distance above the
Rubber Drive Rollers.
Figure 1.
Figure 2.
PAPER HOLD DOWN
ASSEMBLY
ALLEN
HEAD CAP
SCREWS (2)
SHEET EJECT
IDLER ROLLERS
(2)