FujiFilm CR-IR341, Service Manual

Page: 801 / 1472

CR-IR341 Service Manual MU - 18
009-051-05
11.20.99 FM2638
2 3 4 5 6 7 9 10 1 8 C
ONTENTS
MU - 18
FR1H1387.EPS
8.DATA MANAGEMENT : Displays and writes to the hard disk the setup values for "6. FORMAT"
and "7. SHADING/SENSITIVITY."
9.DIAGNOSTIC : Executes all the diagnostic items.
0.QUIT
1.SAVE SHADING AND POLYGON DATA : Writes the shading or polygon data to the hard disk.
2.SAVE SENSITIVITY DATA : Writes the sensitivity correction data to the hard disk.
3.SAVE FORMAT DATA : Writes the format data to the hard disk.
4.DISPLAY DATA : Displays set data for the format or sensitivity. NOTE 2
5.LOAD FROM FD : Reads the data in the floppy disk into the primary memory. The data read
is lost when the machine is reset.
10.VIRTUAL IMAGE : Causes the scanner hardware to generate a virtual image signal,
so that the resulting image is read to isolate the cause of trouble.
0.QUIT
1.LIGHT : Generates virtual light.
2.LOG AMP : Turns OFF the HV to generate an image signal of fixed output.
3.SCN08 INPUT : Causes the SCN08 board to generate an image signal.
4.ROUTINE : Cancel the virtual image signal generation mode to revert back to the initial state.
It should always be performed after the checks are completed in the virtual image
signal generation mode.
3.SHADING / POLYGON CORRECTION : It is set to ON when the corrected data is to be
enabled in routine mode.
4.SENSITIVITY DATA : Performs set sensitivity correction (e.g., leveling the sensitivities of
multiple readers).
Writing the correction value to the hard disk is done in "8. DATA
MANAGEMENT."
5.HV DATA : Should not be used in the market.
6.PMT DATA : Should not be used in the market.
0.QUIT
1.ON
2.OFF
0.QUIT
1.SHADING/POLYGON
2.SENSITIVITY
6.SAVE TO FD : Writes to a floppy disk the shading, polygon, or sensitivity data in the hard disk.
NOTE 1: Numerals in brackets denote a relevant chapter in this manual.
NOTE 2: The abbreviated alphabets displayed have the following meanings.
MP: Number of invalid pixels
TMP: Total number of invalid pixels
TML: Total number of invalid lines
RCNT: Reference frequency division value
NCNT: Oscillation frequency setup value
HVCNT: Center-sensitivity HV value
HVDATA: Reading HV value
PMTK:
PMT sensitivity coefficient
SAIP: IP sensitivity during sensitivity adjustment
Xe: Erasure level dosage
Z: Erasure level QL value
SMD: SHD/polygon correction mode default value
[10.8]
[10.9]
[10.10]