FujiFilm CR-IR341, Service Manual

Page: 569 / 1472

CR-IR341 Service Manual MC - 78 009-051-04
05.31.99 FM2460
2 3 4 5 6 7 9 10 1 8 C
ONTENTS
MC - 78
5.13 Checking and Replacing Shock Absorbers of IP Removal
Unit
■
Check and Replacement
●
Checking and replacing shock absorbers located under IP removal arm
(1) Rotate the timing belt to move up the IP removal unit to nearly the middle stage (away
about 150 mm from the tray of the cassette set unit).
(2) Check if the shock absorber is not peeled or frayed.
If the shock absorber is peeled or frayed, proceed to step (3) to replace the whole
guide to which the shock absorber is attached.
(3) Remove the spring from the wire.
(4) Remove the wire from the roller.
(5) Remove the left roller assembly from the shock absorber-attached guide plate.
(6) Remove the four screws (two of them should be merely loosened) that retain the right
roller assembly, and take out the roller assembly from the bracket.
FRONT
FR1H1427.EPS
Roller
Up-down IP
removal unit
Bracket
IP removal
unit
Spring
Wire
Roller
Loosen screw
BR M4x8, x2
Roller
Roller assembly
Sems M3x6, x2
Roller assembly
Remove screw
BR M4x8, x2
Shock absorber-attached
guide plate
(1)
(4)
(4)
(4)
(3)
(2)
(5)
(6)
(6)
(6)
(4)
Timing belt
(7) Pull out the IP removal arm toward the front.
◆
NOTE
◆
When pulling out the IP removal arm, do not grasp its center. If the center is grasped,
the IP removal arm may be bent.