FujiFilm CR-IR341, Service Manual

Page: 800 / 1472

CR-IR341 Service Manual MU - 17 009-051-05
11.20.99 FM2638
MU - 17
2 3 4 5 6 7 9 10 1 8 C
ONTENTS
FR1H1386.EPS
5.SCANNER UTILITY
: Conducts main-scan system diagnostic checks and setups.
Used during checking or after replacement of main-scan system parts.
0.QUIT
1.INITIALIZE : Loads main-scan system parameters and performs initial
setting for the main-scan system.
2.POLYGON : Rotates and stops the polygonal mirror individually.
3.LASER : Turns ON/OFF the laser individually.
4.HV : Checks whether the high-voltage switch (software switch) is turned ON/OFF normally.
5.HV DATA : Sets the high voltage applied to the photomultiplier. Its setting range is
from 250 to 1000 V.
When it is set to 0, its setting is turned OFF.
7.SHADING/SENSITIVITY : Temporarily records, calculates, and sets the shading or sensitivity
data in order to determine it.
Writing the settings to the hard disk is done in "8. DATA MANAGEMENT."
"9.2 Shading/Sensitivity Correction" in Checks, Replacement
and Adjustment Volume
0.QUIT
1.REC MODE : Makes the shading correction data recordable.
2.CALCULATION : Calculates the shading, polygon or sensitivity correction data.
6.FORMAT : Temporarily sets the IP read start position (PIXEL) and read width (FREQ).
Writing the settings to the hard disk is done in "8. DATA MANAGEMENT."
"9.1 Adjusting Read Start Position and Read Width" in Checks,
Replacement and Adjustment Volume
0.QUIT
1.DEFAULT : Sets the read start position and read width to their initial values.
2.FREQ ADJUST : Adjusts the read width.
3.PIXEL ADJUST : Adjust the read start position.
0.QUIT
1.PIXEL AND FREQ
2.PIXEL ONLY
3.FREQ ONLY
0.QUIT
1.SHADING, POLYGON AND SENSITIVITY
2.SHADING, POLYGON AND SENSITIVITY FOR BAD CONDITION
3.SHADING AND POLYGON
4.SHADING AND POLYGON FOR BAD CONDITION
5.POLYGON ONLY
6.SENSITIVITY ONLY
0.QUIT
1.ON
2.OFF
0.QUIT
1.ON
2.OFF
0.QUIT
1.ON
2.OFF
[10.]
[10.1]
[10.2]
[10.3]
[10.4]
[10.5]
[10.6]
[10.7]
NOTE: Numerals in brackets denote a relevant chapter in this manual.