FujiFilm CR-IR341, Service Manual

Page: 1217 / 1472

CR-IR341
Service Manual
IN - 32 009-051-07
08.30.2001 FM3115
2 3 4 5 6 7 1 8 A1 A2
C
ONTENTS
IN - 32
■
Detailed Explanation of SYSTEM (IRSET.CFG) Setup Items
Items that are not fully described in “List of SYSTEM Setup Items” are explained in detail
below. They should be referred to as needed.
●
“3. IPS” (standard LAN address)
The IP address of the CPU90E board that comes standard with the CR-IR341.
“172.16.0.1
” is set as its initial value ( denotes half-width space). When
the CR-IR341 is connected to a network for operation, it is necessary to determine a
unique (non-duplicate) IP address over the single network and change it to that ad-
dress.
Typically, because the IP address is also determined as the system configuration is
determined, the IP address assigned to the CPU90E board should be checked.
●
“4. IPI” (LAN board address)
The IP address of the CPU90F/LAN90B board that comes as an option with the CR-
IR341. “172.16.0.2
” is set as its initial value ( denotes half-width space).
When the CR-IR341 is connected to a network for operation, it is necessary to deter-
mine a unique (non-duplicate) IP address over the single network and change it to that
address.
Typically, because the IP address is also determined as the system configuration is
determined, the IP address assigned to the CPU90F board should be checked.
Even if the CPU90F board is not available, it should always be set; thus, an IP address
should be assigned to it.
●
“5. ILA” (selection of board for acquisition from IDT)
The board that acquires ID information from the IDT is switched by a value of “0” or “1”.
• “0” : Standard LAN board (CPU90E board)
• “1” : Optional LAN board (CPU90F/LAN90B board)
The setup of “5. ILA” is effective for the IDT type only; thus, for the CSL type, its initial
value should be used as is.
●
“8. SID” (reader number)
Symbol (number), from A through Z, used when several readers (FCR series
machines, including FCR3000) are installed. A unique symbol is assigned to each of
the readers.
Because this symbol is appended to the first digit of the image number, it can be seen
from which reader the image data has been read.
●
“9. SFC” (manual sensitivity setup selection menu)
Used to determine whether manual setting of sensitivity is enabled.
• 0: OFF (Manual sensitivity setting is disabled.)
• 1: Standard/Semi-High-Speed can be selected.
• 2: Standard/Semi-High-Speed/High-Speed can be selected.