FujiFilm CR-IR341, Service Manual

Page: 297 / 1472

CR-IR341
Service Manual
MT - 34
009-051-05
11.20.99 FM2638
MT - 34
2 3 4 5 6 1 C
ONTENTS
2544
Laser power error 2
With laser power status check during read, an error is
detected.
Check and replace the light source unit.
(If no abnormal image results, it should be ignored.)
E-3
2545
HV voltage error 2
With HV voltage status check during read, an error is
detected.
Check and replace the PMT08A board.
(If no abnormal image results, it should be ignored.)
E-3
2546
Analog power supply error 2
Analog power supply error is detected in the PMT08A board.
Check and replace the PMT08A board.
(If no abnormal image results, it should be ignored.)
E-3
2547
Start-point detection error 2
With start-point detection status check during read, an error is
detected. Check and replace the SYN08A board.
(If no abnormal image results, it should be ignored.)
E-3
2548
Leading-edge detection error 2
With leading-edge detection status check during read,
an error is detected.
Check and replace the IP leading-edge sensor
(SED08A).
(If no abnormal image results, it should be ignored.)
E-3
2550
Overexposure detection An overexposed IP is detected during read.
It is because an IP was exposed under overexposure-
equivalent conditions.
E-4
TR1H1248.EPS
2570
Polygon error 3
With status check during system shutdown after reading
error, an error is detected.
Faulty SCN board, scanner hardware, etc.
E-3
2571
Insufficient laser power error 4
With status check after reading condition setup, an error is
detected.
Faulty SCN board, scanner hardware, etc.
E-3
2572
Laser error 4
With status check after reading condition setup, an error is
detected.
Faulty SCN board, scanner hardware, etc.
E-3
2573
Insufficient laser power error 3
With status check during system shutdown after reading
error, an error is detected.
Faulty SCN board, scanner hardware, etc.
E-3
2549
End-of-screen error
Because an end-of-screen interrupt does not occur during
reading and thus a timeout occurs, reading is retried.
Faulty SCN board, scanner hardware, etc.
E-3
Code Name Significance/Occurrence Condition Detail Probable Cause/Remedy Refer to
Detail: Denotes the detail information format.
2535
HV voltage error 1
With initial HV voltage status check, an error is detected.
Check and replace the PMT08A board.
(If no abnormal image results, it should be ignored.)
E-3
2542
Polygon error 2
With polygon status check during read, an error is detected.
Check and replace the polygonal mirror assembly.
(If no abnormal image results, it should be ignored.)
E-3
2543
Insufficient laser power error 2
With laser power status check during read, insufficient power
is detected. Check and replace the light source unit.
(If no abnormal image results, it should be ignored.)
E-3
2530
Interrupt diagnostics error 1
(leading-edge detection)
During scanner self-diagnostics, a leading-edge detection
interrupt does not occur.
Check and replace the IP leading-edge sensor
(SED08A).
E-3
2531
Interrupt diagnostics error 2
(end of screen) During scanner self-diagnostics, an end-of-screen interrupt
does not occur. Check and replace the SCN08A board, polygonal mirror
assembly, scanning optics unit, and SYN08A board.
E-3
009-051-06
04.20.2001 FM3006