FujiFilm CR-IR341, Service Manual

Page: 426 / 1472

CR-IR341
Service Manual
MT - 157
009-051-04
05.31.99 FM2460
MT - 157
2 3 4 5 6 1 C
ONTENTS
13E1
Check the error-related system
block diagram and connect
the connectors as appropriate.
Install the sensor properly.
N
N
Restart the machine
and check its status.
Power OFF
Y
Y
Y
Y
Y
Y
Adjust/replace the following parts.
●
Movable roll
●
Hold pin
●
Cassette
N
Clean/adjust/replace the following parts.
●
Suction cup rubber
●
Suction cup hose
N
Adjust/replace the following parts.
●
Suction cup arm/shaft/bearing
N
Clean or replace the IP.
N
Power OFF
With the cassette set in the
relevant shelf, does the cassette
cover open properly?
Power ON
Does PB1 rotate during
initialization self-diagnostics?
Check the error-related system
block diagram and connect
the connectors as appropriate.
Replace the following parts
in order named.
●
PB1
●
DRV08A board
N N
Power OFF
Power ON
Power OFF
Are the connector connections
from PB1 to DRV08A to JPS-1
board normal?
Replace the following parts
in order named.
●
SB5
●
SNS08A board
Power OFF
Is SB5 installed normally?
Power OFF
Is the connector connection
from SB5 to SNS08A board
normal?
N Y
Y
Y
Is the IP normal?
Make sure that its sucked surface
is not soiled, curled, or bent.
Are the suction cups of the IP
removal unit normal?
●
Check if the suction cups are
installed properly.
●
Check the suction cups for any
soil or deformation.
Power OFF
Is the drive mechanism of the IP
removal unit normal?
●
Move the suction cup arm by
hand to check that it moves
smoothly.
FR1H0127.EPS
Preliminary steps:
1. Power OFF the machine and remove the covers.
2. Turn OFF the high-voltage switch (S1) of the SCN08A board.
3. Check for any foreign matter (lead character marking chips, etc.) inside the machine, and if any, remove it all.
Is SB5 normal?
With "6. MECH" of M-Utility,
execute sensor monitoring to
check the SB5 status.