FujiFilm CR-IR341, Service Manual

Page: 528 / 1472

CR-IR341 Service Manual MC - 37
009-051-04
05.31.99 FM2460
2 3 4 5 6 7 9 10 1 8
C
ONTENTS
MC - 37
(7) Type in the number of the sensor to be checked (SA2, 6, 10, 14).
➮
The machine is now in the sensor monitoring enabled state.
(8) Loosen the screw on the mounting bracket of the sensor to be checked (SA2, 6, 10,
14).
(9) Secure the manual release lever of the cassette set unit in place with a cable tie, so
that the hold pin is withdrawn.
(10) While pushing down the latch by hand, set a scale in such a position that the distance
from the end face of the plate to the tip of the scale is 1.5 mm.
(11) With the tip of the scale in contact with the actuator of the sensor (SA2, 6, 10, 14) to
be checked, slowly move the mounting bracket bit by bit toward the scale and tighten
the screw in place where the sensor changes status from OPEN to CLOSE.
(12) Slide the scale until the distance between the end of the plate and the tip of the rule is
1.0 mm, and make sure that the sensor (SA2, 6, 10, 14) transitions to OPEN.
(13) Repeat steps (6) through (12) to adjust the sensor mounting position.
(14) Cut the cable tie that was attached at step (9).
(15) Select “0. QUIT”.
➮
The screen switches back to “5. MECHANICAL UTILITY” menu.
(16) Select “0. QUIT”.
➮
The screen returns to the main menu.
(17) Power OFF the machine.
(18) Check the sensor adjusted.
➮
“
■
Checks”
SA2, 6, 10, 14
Mounting bracket
BR M4x8
(8), (11)
SA2
Actuator
Plate
SA6
SA10
SA14
Latch
FRONT
End of calipers
Plate end face
Scale
1.5mm : Close
1mm :
Open
FR1H1412.EPS
Scale
(10)
(10)
(10)
009-051-06
04.20.2001 FM3006