FujiFilm CR-IR341, Service Manual

Page: 1361 / 1472

CR-IR341 Service Manual IN - 158 009-051-07
08.30.2001 FM3115
2 3 4 5 6 7 1 8 A1 A2 C
ONTENTS
IN - 158
Machine
Rear
Front
FR1B1058.EPS
700 or more
100 or more
Height: 1800 or more
Unit: mm
Machine
Rear
Front
700 or more
50 or more
Height: 1800 or more
Without clamps With clamps
700 or more 700 or more 200 or more 200 or more
FR1B1057.EPS
Adjustable foot
Seating face on the frame side
Machine
Nut
8.3 Final Placement
For final placement, there are two installation methods. One is to install the machine by
securing it with the clamps that were removed at the time of unloading. The other is to
install the machine without using such clamps. Check the space available for installation,
and consult with the user about his wishes before choosing between the above two installa-
tion methods.
CAUTION
In order to avoid electric shock hazards, power OFF the machine before performing any proce-
dures.
■
Installation Space Required for Final Placement
The space required for final placement differs depending on whether the machine is to be
secured with the clamps or not.
■
Procedure for installing the machine without the clamps
(1) Secure necessary installation space around the machine.
(2) Rotate the four adjustable feet of the machine by hand to bring them into contact with
the floor.
(3) Using a wrench, rotate the lower nut of the adjustable foot to adjust its height.
The four nuts should be rotated equally.
Adjust the amount of nut rotation so as to apply equal pressure to the four adjustable
feet.
◆
NOTES
◆
• Lift up the machine until the casters are free to roll.
• Make sure that all the four adjustable feet are used.
(4) Push the upper nut against the adjustable foot and secure it in place.