FujiFilm CR-IR341, Service Manual

Page: 1369 / 1472

CR-IR341 Service Manual IN - 166 009-051-07
08.30.2001 FM3115
2 3 4 5 6 7 1 8 A1 A2 C
ONTENTS
IN - 166
■
Check for Output Characters
Make sure that the contents of the film character format information that has been set in “2.
CONFIGURATION SETTING” of M-Utility are indicated accurately on the film outputted in “
■
Check for Jitters.”
If anything abnormal is found with the output characters, take remedial measures as appro-
priate.
“3. Troubleshooting Procedures Based on Abnormal Images” in Troubleshooting
●
Normal two-image output characters
●
Other image output patterns and character display areas
SUPPLEMENTARY NOTE
The output characters indicated in the character display areas (A and B) are variously laid out depend-
ing on the employed output pattern.
FR1B1119.EPS
: PEM information or Ene.-Sub./
superposition information u
b c a d
Normal two-image output
Image
f
g
i
j l s
m
k n
o
p
r q t h
u
Character
display
area B
Character display area A
e
a : Hospital name (institution name)
b : IP number
c : EDR mode and menu code
d : System ID and image number
e : Image processing conditions
f : Exposure menu name
g : Standardization conditions and
amendments
h : Engineer code and exposure
table information
i : Department name
j : Patient ID
k : Patient name (Kana)
l : Patient name (Kanji)
m: Exposure date and time
n : Film mark
o : Sex
p : Age or birth date
q : Image reduction ratio
r : Set processing information
s
R : Left-right reversal mark ( )
t : Data compression code
❍
Below the image area
❍
Above the image area
Image
One-image output
A
B
Image
FR1B1120.EPS
Pantomo two-image output
A
B
Image
A
B
Image
FR1B1122.EPS
14" x 17" 100% magnification output
A
B
Image
A
B
FR1B1121.EPS