FS M6500 Series, Configuration Manual

Page: 167 / 185

M6500 Series NE Configuration Manual
166
Figure9-59 Optical Module of Ethernet Not In Position
Here are the situations when the monitoring data for the board is shown as NA:
(1) When the board is not in position or is pre-configured with an empty slot and the port for the board is
enabled, all the data will be shown as NA.The suspicious interval is marked as untrustworthy, and the running
time is always 0 without any change, as shown in figure below:
Figure9-60 Ethernet Monitoring Data
(2) When the board is mismatched and the port for the board is enabled, all the data will be shown as NA. The
suspicious interval is marked as untrustworthy, and the running time counts from 0 without any change, as
shown in the figure below:
Figure9-61 Ethernet Monitoring Data When Mismatched
9.3. History Performance Statistics
9.3.1. History Performance Statistics of Optical Power
9.3.1.1. History Monitoring Parameters Introduction of Optical Power
The monitoring parameter of the history monitoring point for optical power includes time interval, which is a
shortcut to choose the time. There are three options--one day, three days and a week for you to choose.
Duration: You can choose a specific day or a period of time according to your needs.
Performance Monitoring Point: entrance-near end, exit-near end.
Performance Monitoring Parameters: maximum optical power, minimum optical power, average optical power.