FS M6500 Series, Configuration Manual

Page: 123 / 185

M6500 Series NE Configuration Manual
122
Create SNC cross-connection with protection.
Select SNC protection type--SNC/I or SNC/N.
Reply Wait Settings Set reply mode—Reply Mode or Non-reply Mode.
If it is set as “non-reply mode”, it indicates that after the service is
reversed to the secondary channel, even if the primary channel recovers
to normal, the service will still work on the secondary channel until
failure occurs to the secondary channel.
If it is set as “reply mode”, it needs to simultaneously set the reply
waiting time. It indicates that after the service is reversed to the
secondary channel, if the primary channel recovers to normal, the
service will immediately return to the primary channel or recover to the
primary channel after the reply waiting time.
The settings for the two ends of the protection equipment should keep
consistent.
Protection Switching Command
Settings Manually select the issuing external command.
Delete Protection Settings Manually delete the protection channel/working channel.
7.3. Configuration Example
The SNC service types supported by various Shelf and boards are listed in the following table.
Table7-2 Supported SNC Service Type Table
Shelf Type Board Type Supported SNC Service Type
M6500-CH5U M6500_MXP10 10G service board SNC protection
10G service cross board SNC protection
M6500-100G-TMXP2 100G service cross board SNC protection
M6500-40G-TMXP2 40G service cross board SNC protection
M6500-CH2U M6500_MXP10 10G service board SNC protection
10G service cross board SNC protection
M6500-100G-TMXP2 100G service cross board SNC protection
The demultiplexing capacity corresponding to the service type is shown in the following table:
Table7-3 TP Multiplexing Capacity Table of SNC Service
Service Rate Service Type Capacity Type
1.25G Service GE_TTT
ODU0
FE_CBR
STM1_GMP/OC3_GMP
STM4_GMP/OC12_GMP
2.5G Service STM16_AMP/OC48_AMP ODU1