FS M6500 Series, Configuration Manual

Page: 112 / 185

M6500 Series NE Configuration Manual
111
Demultiplex ODU4 to ODU2e, configure service cross-connection, connect optical fiber and build the
environment.
For line side Port 11: If the status of ODU layer is“unterminated”, then only expected TTI can be set, but sent TTI
cannot be set. It is used as a monitoring function, which checks whether the signal received on the line side is
correct.
For client side Port 1: If the status of ODU layer is“client side signal terminated”, then both expected TTI and sent
TTI can be set. They are used to test the signal, which tests whether the client side signal sending source and
receiving source are correct. The PM overhead configuration of the opposite end is the same as that of the local
end. We will not go into too much detail.
Figure6-10 Enter Line Side Port Management Interface
Figure6-11 Enter Line Side ODU2e Management Interface