FS M6500 Series, Configuration Manual

Page: 72 / 185

M6500 Series NE Configuration Manual
71
Figure5-15 STM64_AMP Mapping Mode
5.2.2.2. BMP
BMP (Bit-synchronous Mapping Procedure BMP) requires the rate of the service layer signal to match that of the
client layer signal, and there is no frequency deviation.
Here we take M6500-MXP10 board as an example. Select NE-Slot, click on“ Port1 ”and select“ Port
Management ”on the right, and then select XGE_BMP mode.
Figure5-16 XGE_BMP Mapping Mode
5.2.2.3. GMP
For GMP (Generic Mapping Procedure), in all cases (such as the maximum ppm frequency offset of the client
signal and the minimum ppm frequency offset of the server signal), the rate of the server signal must be higher
than the rate of the client signal. Any rate of the client signal can be mapped to any server payload rate by using
this method, that is, the rate of the service layer is required to be greater than that of the client layer; otherwise,
it cannot be transmitted.
Here we take M6500-TMXP5 board as an example. Select NE-Slot, click on“ Port 3 ”and select“ Port
Management ”on the right, and then select HGE_GMP mode.