FS M6500 Series, Configuration Manual

Page: 13 / 185

M6500 Series NE Configuration Manual
12
2. Create Network
Create network topology, that is, create corresponding network model of actual project according to the
configuration of actual engineering (such as networking, single site configuration etc.), so as to realize the
monitoring of devices.
Before creating a network topology, operators need to know the relevant engineering configuration files,
including:
 Information such as the NE type and single card configuration of each site.
 Network topology of engineering.
 Service scheduling and protection scheme.
If an operator only needs to add a network element to an existing project, he only needs to know the location
and topological connection of the network element in the actual network.
It will introduce the creation steps of the network topology according to the configuration process in the
following passage. Moreover, it will focus on the parameter configuration related to M6500in each step, and
only the sections of the reference book will be provided for the common configuration steps for each device. M
Series NMS related software was pre-installed when the network management host was manufactured. When
the network management host was turned on, the network topology could be created according to the
configuration process. This chapter includes the following content:
 Create Network Flow
 Login NMS Interface
 Create Nodes
 Add NE
 Establish Network Element connection
 Management of Network Elements
 Check Configuration Data
 Save Configuration Data
2.1. Network Creation Process
The topology of subnet, network element and fiber cable can be created in M Series NMS. Network element
data can be configured.The single board parameters can be checked or modified, and further the subnet,
network element or fiber cable can be managed by M Series NMS.
To create network, you can take the following process as reference: