Foma N901iS, User Manual

Page: 482 / 580

480
Data Comm
unication
(Communicating, sending data)
(Communicating, receiving data)
(Communicating, no data transfer)
(Sending, or disconnecting)
(Receiving, or disconnecting)
●
appears on the FOMA terminal during 64K
data communication.
How to disconnect
Since just closing the browser on your PC may
not disconnect, be sure to disconnect by the
following procedure:
1 Double-click the dial-up icon in
the Task tray
The connecting screen will be displayed.
2
Click “ 切断 ” (Disconnect)
When this happens
●
Check the following if you cannot connect to the
network or dial-up successfully.
Uninstalling the FOMA PC Setting Software
This section describes uninstallation instructions
for FOMA PC setting software.
● When uninstalling the “FOMA PC setting
software” from Windows 2000/Windows XP, be
sure to log on as Administrator. If you attempt to
uninstall the software with another account, an
error occurs. Contact your PC’s manufacturer or
Microsoft for information on how to set
Administrator privileges on your PC.
1
Before uninstalling
Before starting the uninstallation process of the
“FOMA PC
設 定ソ フ ト ” (FOMA PC setting
software), the various changes made for FOMA
must be returned to their original settings.
(1) Disable the “W-TCP settings” in the
task tray
Right-click the “W-TCP icon” in the task
tray located at the right-bottom of the
desktop and select “
常 駐 さ せ な い ”
(Disable resident).
(2) Exit any running program
If you try to begin uninstallation while the
“FOMA PC setting software” or “W-TCP
settings” is in operation, the screen as
shown below will appear. Stop the
uninstallation program and exit the
respective programs.
NOTE
● The communication speed displayed on the PC may
be different from the actual communication speed.
Problem Points to check
“FOMA
N901iS” is
not
recognized
by the PC. ・ See if your PC satisfies the operational
environment required (P.469).
・
See if the N901iS communication
setting file has been installed.
・ See if the FOMA terminal is connected
to the PC and the power is turned on.
・ See if the FOMA USB Cable is firmly
connected.
・
See if the USB mode setting (P.388) is
set to “Communication mode”.
Dial-up icon
Unable to
connect
with the
access
point. ・ See if the settings for the ID (user
name) and password are correct.
・ See if the FOMA USB Cable is firmly
connected.
・ If the access point requires the Caller
ID, make sure that “184” is not added to
the phone number.
・ See if the box of “ フロー制御を使う ”
(Use the flow control) of the modem
property is checked.
・ See if the APN is set correctly.
・ If you still cannot connect to the other
end after checking the above, consult
with the Internet service provider or
network administrator about the setting
method.
Problem Points to check
Right-click
Click