Foma D702i, Manual

Page: 76 / 405

74
Making/
Rec
e
iv
ing Vid
e
o
phone Cal
ls
● If a videophone call cannot be made, one of the following message is displayed on the screen and then the
standby display returns. Note that the displayed message may not reflect the status of the other party’s
terminal correctly, depending on the type of the terminal and/or the network service used by the other party.
●
If a videophone call made is not connected, redialing is automatically performed as described below:
When a videophone call has been made by specifying a multi number, redialing will be made with the specified
number.
If redialing as voice call occurs, voice call charges apply.
● When there is an incoming call during dialing or redialing a videophone call, the dialing may be interrupted and
the ring tone may sound.
● Even if sending/receiving the voice or image is aborted and (only voice) or (only image) is displayed
during a videophone call, the call may be continued as it is.
● Videophone at 32K is intended for connection with devices such as PHS with which videophone calls at 64K may
not be available depending on the network condition. When a videophone call is made at 64K, the call type is
automatically switched to 32K when redialing if the communication environment of the other party is found to be 32K
area. When
ON
is set for
Auto redial as voice
in Videophone Settings, redialing at 32K is also given priority.
☛
P81
･
Even if a call is made at 32K, the charge is the same as digital communication charge at 64K.
● If a videophone call is made to emergency calls (110, 119 or 118) from FOMA terminal while
Auto redial as voice
is set to
ON
in Videophone Settings, the call automatically switches to a voice call.
Switching from a videophone call to a voice call
You can switch to a voice call by operating from the submenu during a videophone call when the
other party’s terminal can switch calls. Switching can be performed only from the terminal which
made the videophone call.
･
This operation can be performed between the terminals that support switching between voice call/
videophone call.
･
To switch to a voice call, the other party needs to set
Indication ON
of Notify Switchable Mode in
advance.
☛
P83
1
m1
during a videophone call
z
Select
YES
Message Description
Check number, then redial . You dialed the phone number not used.
Busy. The other party is busy or during a packet communication.
Out of service area/power off
. The other party is outside the service area or the other party’s terminal is turned off.
Set caller ID to ON. This message is displayed in case connecting without notifying the caller ID
(when accessing to V-Live or visualnet).
Redial using voice call . This message is displayed when the other party sets Voice Mail Service or sets
Call Forwarding Service and the forwarding destination is the terminal which is
not compatible with videophone.
Connection failed. Set Caller ID Notification to Notify and dial again.
･
The message may appear in cases other than the above.
Call type Auto redial as voice setting Redialing operation
64K ON 64K → 32K → Voice call
OFF 64K → 32K → Disconnection
32K ON 32K
→
Voice call
OFF 32K
→
Disconnection
Making v
ideophon
e
c
a
lls