Foma D702i, Manual

Page: 245 / 405

243
i-
channel
Basic channels are available for free of service
charge for a set period of time to i-mode subscribers
who use an i-channel compatible terminal, and who
have never signed up for the subscriber line.
However, packet communication fee caused by
viewing detail information from the channel list is to
be borne by the users.
･
For important notes on using Trial channel and
detail information about how to use the service, see
“i-mode User’s Manual”.
In principle, Trail channel automatically begins after a
set amount of time once the UIM (FOMA card) is
inserted and the i-channel compatible terminal goes
into use. If Trial channel does not start automatically,
you can start it by pressing
c
.
Trial channel is available only once per subscriber line.
Trial channel automatically stops after a certain
period of time following the launch. For information
about how to stop the channel, see “i-mode User’s
Manual”.
INFORMATION
●
Neither ring tone nor vibrator operates at the
reception of information. The keys do not light or
flash, either.
●
When Show ticker is set to No in Ticker Setting, no
tickers are displayed.
●
If you cancel i-channel or i-mode service
subscription, tickers are no longer displayed.
Pressing
c
displays the pre-subscription screen.
Until the cancellation procedure has finished,
however, tickers may be displayed on the screen
and pressing
c
may display the last received
information in the channel list.
●
In case FOMA terminal has been turned off or the
information cannot be received due to the
out-of-service area or poor signal quality, press
c
to receive the information.
●
blinks during reception of information.
Menu 281
Displaying i-channel
Channel List
1
c
The channel list appears.
･
When video/i-motion, Chara-den or i-
α
ppli is
set as the standby display:
d81
･
i-channel cannot be displayed even if
c
is
pressed.
2 Select the channel
Your terminal connects to the site and the
information appears.
･
Depending on the situation, information may be
received when displaying the channel list.
Trial channel
Changing the i-channel host
You can change the i-channel host (although you
usually do not need to change it).
a
d95
b
Highlight the user host
z m z
Enter your
terminal security code
c
Select each item to set
z p
･
Host address2
should be filled with the address
of the i-channel host (up to 30 one-byte
characters).
･
Host address
is the host for i-mode.
☛
P176
d
Select the host you have edited
z p
●
If you enter or change the address of Host
address2 , the i-channel information will no longer
be displayed on the standby ticker. Sometimes,
the information will not be updated
automatically. When you press
c
on the
standby display to view the channel list, the
latest information is received and the tickers are
shown on the standby display.
Channel List