Flavor Burst TS 80BLD, Manual

Page: 52 / 96

51
3. Use the ampule provided to prime the area
within the markings before mounting the
Touchscreen bracket.
AMPULE
26120
NOTE:
LIQUID INSIDE THE AMPULE
ENHANCES ADHESION.
4. With the bracket still assembled, remove the
protective covering from the adhesive strip
on the bottom of the bracket plate. Carefully
place the assembly within the markings and
hold in place.
26121
5. Unscrew the hand knobs from the bracket
plate and remove the Touchscreen
Assembly, allowing the bottom plate to
remain on the freezer. Allow the bottom
plate adhesive to cure
for at least 1 hour .
26122
NOTE:
IF THE ADHESIVE DOES NOT HAVE
TIME TO CURE PROPERLY, THE CONSTANT
WEIGHT OF THE TOUCHSCREEN CAN PULL
THE ADHESIVE AWAY FROM THE FREEZER
SURFACE. THIS COULD EVENTUALLY
RESULT IN THE TOUCHSCREEN ASSEMBLY
FALLING OFF THE FREEZER.
6. When the plate has had time to cure, mount
the Touchscreen Assembly back onto the
plate. Tighten the hand knobs to secure.
26127
7. Connect the switch extension into the stereo
plug on the side of the Touchscreen.
26155
8. For Taylor Crown Series freezers, an
integrated switch should already be built
into the freezer. Typically, the switch jack is
located just under the freezer door and to
the left. Insert the other end of the switch
extension into the switch jack and ensure
the connection is fully engaged.
26125