Flavor Burst TS 80BLD, Manual

Page: 60 / 96

59
Power Connections and Power Up
The electrical connections for the TS 80BLD
are located on the upper back panel of the unit.
Once the connections have been made and the
unit is turned on, the TS 80BLD can remain on
during normal operations from day to day. It
does not need to be turned off unless it is being
serviced or moved, or unless it is not used for a
long period of time.
NOTE:
ELELCTRICAL HAZARD - DO NOT
HANDLE OR OPERATE NEAR WATER.
NOTE:
FB JR UNITS MAY HAVE THE
CONNECTIONS ON THE SIDE OF THE UNIT
AS WELL AS THE BACK OF THE UNIT.
1. Ensure the power-switch is in the “off”
position with the “
○
” end pressed in. The
round connection piece under the switch is
where the Touchscreen cable will connect.
26220
2. Secure the Touchscreen power cable to the
syrup pump cable connection.
26221
3. Plug the power cord into the panel outlet.
26222
4. Plug the power cord into a grounded power
source.
5. Activate the unit by pressing the “
|
” end of
the switch.
26223
6. Flip the power switch on the side of the
Touchscreen to “on.” It will power-up with a
bright blue screen.
OFF
ON
26359
7. Most likely, settings on the Touchscreen will
need to be adjusted according to the
operator’s preference. Serving modes,
flavor timing, serving sizes, changing the
menu flavor names and more are outlined in
the TOUCHSCREEN OPERATIONS
section of this manual. For the initial set-up,
however, proceed with the rest of this
section before making those adjustments.