Flavor Burst TS 80BLD, Manual

Page: 32 / 96

31
8. Press the WATER / SYRUP FLUSH key.
Back Done
Maintenance
Setup Options
Prime Syrup Pump
Serving Counter
Timing Settings
Water/Syrup Flush
Menu Setup
Adjust Dispense Rate
26544
9. The system is now in the Water / Syrup
Flush mode. Press the flavor of the line you
wish to flush.
Done
Back Water/Syrup Flush
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Injector Flush
26580
10. The next screen will remind you to connect
the Pump Flush Adapter (or Flush Line) to
the flavor connector, which you should have
already done in Step 5. It will also show a
START / STOP key.
Back Water/Syrup Flush
Connect Water Flush
Line to flavor connector
P2 - 1
and place container under spout
to collect flushed syrup
Start/Stop
26581
11. To flush the syrup line, press the START /
STOP key. Sanitizer solution will begin to
clear out the syrup line.
Chocolate
26255
NOTE:
WATER / SYRUP FLUSH WILL
CONTINUE FOR 15 MINUTES. YOU MAY
CANCEL AT ANY TIME BY TOUCHING THE
FLAVOR KEY AGAIN. HOWEVER, THE
SYSTEM
MUST COMPLETE A FULL 15
MINUTE FLUSH PROCESS FOR EACH
SYRUP LINE
IN ORDER TO COMPLY WITH
SANITATION GUIDELINES.
NOTE:
WHILE LINES ARE FLUSHING,
PROCEED TO STEPS 12-21.
12. While the line is flushing, pull the tray
forward and remove the syrup bag. Discard
the syrup bag if it is empty or expired. If the
bag has usable syrup, store the syrup as
directed on the label.
26190
13. Clean the syrup tray with a single service
towel and detergent water, rinse and dry.