Flavor Burst TS 80BLD, Manual

Page: 45 / 96

44
Replacing Blending Head O-Rings
The Blending Head o-rings are wear items and
will need to be replaced periodically. Always
keep spares of these items on hand in the
Spare Parts Kit for replacement.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the worn o-rings from the Blending
Head. A small tool may be needed to
remove the two o-rings in the syrup line
opening.
3. Brush and clean all exposed surfaces of the
Blending Head with detergent water. Use a
small brush to ensure that the syrup orifices
are clear of any residual syrup.
4. Place the Blending Head and the new
replacement o-rings in an approved
sanitizer solution and soak for at least 1
minute.
5. Remove the o-rings and Blending Head and
place them on a sanitary tray to dry.
6. Place the larger o-ring into the groove on
the underside of the Blending Head.
26020
7. Apply food-grade lube to the two syrup port
o-rings and then place them into their
respective places inside the syrup port. A
small tool may be used to ensure the
o-rings are fully seated in the grooves.
26021
NOTE:
O-RINGS MUST BE COMPLETELY
SEATED TO PREVENT LEAKAGE.