Flavor Burst TS 80BLD, Manual

Page: 43 / 96

42
Priming the Syrup System
Priming the syrups is necessary when first
installing the flavors, after the Clean-In-Place
procedure, when an individual flavor or multiple
flavors remain idle for more than 72 hours, and
when changing flavors. Only the syrup lines
directly involved will require this process.
1. From the Touchscreen main menu, press
the SETUP key in the upper left corner.
Enter the password if required.
Injector Flush
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Setup
26501
2. Select MAINTENANCE.
Exit
Setup and Maintenance
System Setup
Maintenance
26531
3. Press the PRIME SYRUP PUMP key.
Back Done
Maintenance
Setup Options
Prime Syrup Pump
Serving Counter
Timing Settings
Water/Syrup Flush
Menu Setup
Adjust Dispense Rate
26547
4. The system is now in the Prime Syrup
function mode.
Done
Back Prime Syrup Pump
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Injector Flush
26583
NOTE:
IF THE FLAVORS INSTALLED ARE
DIFFERENT THAN THE FLAVORS ON THE
MENU, YOU WILL NEED TO CHANGE THE
TOUCHSCREEN MENU LABEL FOR THAT
SYRUP LINE. SEE THE “TOUCHSCREEN
OPERATIONS – ASSIGNING FLAVORS TO
THE MENU” FOR INSTRUCTIONS.
5. To prime the syrup line, place a container
under the Blending Head. Press the flavor
key and allow the syrup to flow to flush out
the sanitizer solution and any air pockets.
Chocolate
26251
6. Once syrup flows consistently from the
Blending Head, press the flavor key again to
complete the procedure.
NOTE:
THE PUMP FLUSH FUNCTION WILL
SHUT OFF AFTER 15 MINUTES.
7. Repeat this entire process for each syrup.
8. When all the syrup lines have been primed,
press the INJECTOR FLUSH key to clean
the Blending Head.
Injector Flush
26250
9. Press DONE to exit the Prime Syrup Pump
mode and return to the main screen.
Done
26508