Flavor Burst TS 80BLD, Manual

Page: 47 / 96

46
Blending Assembly Suspension Bracket
Detergent
CLEAN
Water
RINSE
DRY
SANITIZE
26145
1. Remove the Bracket from the Blending
Assembly and disassemble it.
2. Clean the Bracket parts using detergent
water and brush if necessary, then rinse
thoroughly.
3. Place the items in sanitizer solution for at
least 1 minute.
4. Remove parts from the sanitizer solution
and place them on a sanitary tray to dry.
5. Reassemble and reinstall the Suspension
Bracket as directed in EQUIPMENT
SETUP.
Tube / Cable Casing Assemblies
Detergent
CLEAN
Water
RINSE
DRY
26146
1. Remove the Tube / Cable Casing
Assemblies from the freezer.
2. Using warm detergent water and a single
service towel, clean the two Casings
attached to the freezer.
3. Rinse with a single service towel moistened
with clean water.
4. Dry the Casings with a dry single service
towel.
9-Tube Assembly Syrup Lines
Detergent
CLEAN
Water
RINSE
DRY
26143
1. If it is necessary, follow instructions in
‘Phase 1’ and ‘Phase 3’ of the Clean-In-
Place procedure to clean and sanitize the
Coupler Body, Syrup Line Manifold, and the
Duckbill Check Valve.
2. Clean the Coupler Base, the end of the
syrup lines and the outside of the syrup
tubes with a single service towel moistened
with detergent water.
3. Rinse the parts using a single service towel
and warm water, then dry with a dry single
service towel.
4. Reassemble the 9-Tube Assembly if
necessary according to instructions in
‘Phase 4’ of the Clean-In-Place procedure.