Flavor Burst TS 80BLD, Manual

Page: 41 / 96

40
25. If the 15-minute flush procedure is finished
and the Pump Flush Adapter is
disconnected from the syrup line, clean and
sanitize the bag fitment and the syrup
connector with detergent water. Brush the
bag fitment with the Medium Brush and the
Connector with the Small Brush. Then rinse
and dry the parts using clean water and
single service towels.
Detergent
CLEAN
Water
RINSE
DRY
26276
26. Use a spray bottle of approved sanitizer, to
spray the exposed surfaces of the bag
fitment and the Syrup Bag Connector. Let
the solution sanitize these parts for at least
1 minute.
26271
CIP - Phase 4: Reassemble
NOTE:
SYRUP BAGS MANUFACTURED IN
2016 AND LATER HAVE A NEW DIRECT
CONNECT NOZZLE FITMENT. THEY
CONNECT DIRECTLY TO THE SYRUP LINE
CONNECTOR AND NO LONGER REQUIRE A
SYRUP BAG ADAPTER OR LOCK. USE THE
ADAPTERS AND LOCKS ON SYRUP BAGS
WITH THE WIDE FITMENT.
27. If all the newly installed bag have direct
connect nozzle fitments, skip to Step 30. If
you have a wide bag fitment that requires a
lock and bag adapter, perform the next
couple of steps on those bags.
28. Attach a Syrup Bag Adapter to each syrup
bag fitment. The notch of the black collar
must settle into one of the grooves on the
fitment in order to secure the connection.
NOTCH MUST
SETTLE INTO
GROOVE
26077
29. Slide a syrup bag lock over each adapter
and bag fitment.
26057
NOTE:
THE ADAPTER VALVE CAN BE
TURNED IN ANY POSITION SO THAT THE
SYRUP TUBES ARE NOT PINCHED.