Flavor Burst TS 80BLD, Manual

Page: 35 / 96

34
29. Repeat Steps 3-28 for any additional flavors
that are being changed out.
30. After the syrup line in sanitized, select
“Priming Functions” in the Maintenance
Menu.
31. Prime the syrup lines of the new flavors.
From the Touchscreen main menu, press
the SETUP key in the upper left corner.
Enter the password if required.
Injector Flush
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Setup
26501
32. Select MAINTENANCE.
Exit
Setup and Maintenance
System Setup
Maintenance
26531
33. Press the PRIME SYRUP PUMP key.
Back
Done
Maintenance
Setup Options
Prime Syrup Pump
Serving Counter
Timing Settings
Water/Syrup Flush
Menu Setup
Adjust Dispense Rate
26547
34. The system is now in the Prime Syrup
function mode.
Done
Back Prime Syrup Pump
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Injector Flush
26583
NOTE:
IF THE FLAVORS INSTALLED ARE
DIFFERENT THAN THE FLAVORS SHOWN
ON THE MENU, YOU WILL NEED TO
CHANGE THE TOUCHSCREEN MENU LABEL
FOR THAT SYRUP LINE. SEE THE
“TOUCHSCREEN OPERATIONS –
ASSIGNING FLAVORS TO THE MENU” FOR
INSTRUCTIONS.
35. To prime the syrup line, place a container
under the Blending Head spout. Press the
key of the flavor that was installed and allow
the syrup to flow until there are no air
pockets in the syrup line.
Chocolate
26251
36. Once syrup flows consistently from the
Blending Head, press the flavor key again to
complete the procedure.
37. Repeat Steps 34-35 for each syrup line that
is to be primed.