Flavor Burst TS 80BLD, Manual

Page: 25 / 96

24
Installing the Blending System
The Spout Adapter o-ring is a wear item and
will need to be replaced periodically. Check for
wear and always keep spares of these items on
hand in the Spare Parts Kit.
1. Ensure the o-ring is on the Spout Adapter.
Snap the adapter onto the freezer spout.
Push up on the adapter with your palm to
ensure it is evenly and fully installed.
26138
2. Hang the Suspension Bracket with the
Blending Assembly on the door posts.
26040
3. Install the Blending Head fully over the
Spout Adapter. Rotate the locking collar
over the Adapter tabs to secure.
26042
4. Connect the Drive Motor cable to the Motor.
26048
5. Ensure that the Blending Assembly is level
horizontally and make any adjustments to
the Suspension Bracket as needed using
the adjustment hand knob.
LEVEL
26084
6. Insert the Syrup Line Manifold end fully into
the Blending Head syrup line opening.
Rotate it until motion stops to secure.
26044
7. With a container under the dispensing
spout, press the INJECTOR FLUSH key on
the Touchscreen to purge any remaining
product from the Blending Head.
Injector Flush
26250