[email protected]
whatsapp:959440045
6.1
Inlet/outlet and bowl
6
Dismantling & Assembly
18. Fit lock ring (9). Apply a thin layer of Molykote
Paste 1000 to the threads and on contact and
locating surfaces.
Left-hand thread!
G0074331
19. Fit frame hood (8).
The two eye-bolts must be fitted in the holes
nearest to the electric motor.
In case of Major Service remove the connecting
housing and fit a new O-ring on the insert (2).
Check point
5.4.1 Paring disc height adjustment
on page 49
. To be performed at Major Service
and if the bowl spindle has been dismantled.
G0073581
20. Fit inlet/outlet housing. Tighten nut.
Left-hand thread!
21. Then rotate the bowl by means of the flat belt.
If the bowl does not rotate freely or a scraping
noise is heard, incorrect bowl assembly or
incorrect height adjustment of the paring disc
can be the cause.
NOTE
To avoid damage on the inlet pipe the tightening torque
must not exceed 30 Nm.
22. Make sure that the gasket on the safety device
is in position. If not, glue with Loctite 407. Fit
and secure safety device.
23. Fit the connecting hoses if they have been
removed. Make sure to fit their gasket rings.
24. Fit the water tank on the frame bottom part if
it has been removed.
G0172951
96
www.fdm.com.pe