[email protected]
whatsapp:959440045
6.1
Inlet/outlet and bowl
6
Dismantling & Assembly
9.
Assemble the bowl discs with wing insert and
top disc on the distributor. Note the angular
positioning (six options). Ensure that the pins
in the distributor fit properly into the holes of
the top disc.
10. Preparations for lifting in the disc stack
-
Fit the compression tool and screw down the
central screw until it stops
-
Tighten the compression nut by hand
11. Fit the disc stack assembly in the bowl body.
Make sure that the cuts in the wings on the
underside of the distributor fit properly in the
corresponding lugs of the bowl.
G0357561
12. Fit bowl hood (15):
-
Apply a thin layer of Molykote Paste 1000 to
threads and on contact and locating surfaces.
-
Fit the spanner for the bowl hood and secure it
with the bolt (a).
-
Screw on the bowl hood by hand.
Left-hand thread!
G0072231
13. Fit the compressing tool and screw down the
central screw (b) until it stops. Compress the
disc stack by tightening the nut (a) firmly.
NOTE
Use the compression tool as instructed. Use of
substitute tools can damage the equipment.
Check point
G0072361
94
www.fdm.com.pe