[email protected]
whatsapp:959440045
5
Service instructions
5.9
Lubricants
5.9
Lubricants
5.9.1
Lubrication chart, general
Alfa Laval ref. 553216-01 Rev. 8
Lubricating points
Type of lubricant
Interval
The oil bath
.
Bowl spindle ball bearings are
lubricated by oil splash from the
oil bath.
Lubricating oil as specified in
5.9.3 Recommended lubricating
oils on page 63
See
Oil Change:
1. Continuous operation: 2000h
2. Seasonal operation: Before
every operating period.
3. Short periods operation: 12
months even if the total number
of operating hours is less than
stated above.
Bowl spindle taper.
Lubricating oil (only a few drops
for rust protection).
At assembly
Bowl:
Sliding contact surfaces, thread
of lock nut and cap nut.
Pastes as specified in
5.9.2
Recommended lubricants on
page 60
.
At assembly
Rubber seal rings.
Grease as specified in
5.9.2
Recommended lubricants on
page 60
.
At assembly
Friction coupling ball
bearings.
Not valid for rigid coupling.
The bearings are packed with
grease and sealed and need no
extra lubrication.
-
Electric motor
Follow manufacturer’s
instructions.
Follow manufacturer’s
instructions.
Threads
Lubricating oil, if not otherwise
stated.
At assembly
NOTE
If not otherwise specified, follow the suppliers
instructions about applying, handling and storing of
lubricants.
Instructions related to a specific design of the machine
refer to general assembly drawings.
!
CAUTI
ON
Check the oil level before start.
Top up when necessary.
Do not overfill.
59
www.fdm.com.pe