Fayat Dynapac F80W, Operating Manual

Page: 98 / 198

92 F80W
1
2
3
4
451083
5
2.5 Operation of the machine
2.5.18 Conveyor limit switch
If the automatic mode of the conveyor is set, it is possible to
control the quantity of the delivered material to augers by set-
ting the conveyor limit switch.
The conveyor limit switch assembly consists of the limit switch
(1) and the limit switch arm (4).
The quantity of the material delivered to augers can be con-
trolled by extending and retracting the limit switch arm (4), or to
increase the setting range of the delivered material, by shifting
the conveyor limit switch assembly on the holder (5).
Procedure for setting the conveyor limit switch:
• Adjustment by means of the limit switch arm:
- Set the required position of the limit switch arm (4).
- Loosen the lock screw (3)
of the limit switch arm (4).
- To increase the quantity of the delivered material, re-
tract the limit switch arm (4).
- To reduce the quantity of the delivered material, extend
the limit switch arm (4).
- Tighten the lock screw (3) of the limit switch arm (4).
• Adjustment by shifting the limit switch assembly:
- Set the required position of the limit switch assembly (1).
- Loosen the lock screw (2) of the limit switch assembly (1).
- To increase the quantity of the delivered material, move
the limit switch assembly (1) upwards.
- To reduce the quantity of the delivered material, move
the limit switch assembly (1) downwards.
- Tighten the lock screw (2) of the limit switch assembly
(1).
Caution! When setting the conveyor limit switch, the en-
gine of the machine may not be started.
There is a risk of burns when adjusting the limit switch.
Use protective equipment when adjusting the limit
switch.