Fayat Dynapac F80W, Operating Manual

Page: 171 / 198

165 F80W
D451113B
8
9
451194
MIN MAX
MAINTENANCE MANUAL
Procedure for oil volume check in the engine:
• Start the engine.
• Leave the engine to idle for at least for 5 minutes.
• Turn off the engine.
• Wait approximately for 5 minutes before oil flows to the
sump and check the level again.
• Pull out the oil dipstick gauge (8), wipe it.
• Put is back up to the stop, pull out again and read height of
the level.
• If required, fill up the oil through the filler neck (9) after tak-
ing pout the oil dipstick gauge (8).
Note
• The lower “MIN” mark shows the lowest possible oil level, the
upper “MAX” mark the highest possible oil level.
• After refilling, wait approximately for 5 minutes before oil
flows to the sump and check the level again.
Clean the engine oil filter when the machine is parked on
a flat and solid surface, the engine and the battery dis-
connector are off and the gas bottle is closed.
When cleaning the engine oil filter, wear the prescribed
protective equipment.
There is a risk of burns from the hot parts of the engine.
There is a risk of eye injury when cleaning the engine oil
filter with compressed air.
Do not use the engine unless the oil level in the engine
is correct.
The oil level should be maintained between the marks
stamped on the oil-gauge rod.
Use the same type of oil for refilling as given in Chapter
3.2.1
Stop the oil soaking into the ground.