Fayat Dynapac F80W, Operating Manual

Page: 58 / 198

52 F80W
2.2.1 Storage places and storage conditions
The machine can be stored under a shelter or in an open-air
space. The machine can be stored in closed unheated areas or
in closed air-conditioned areas as well.
Before the machine is stored, it must be checked and its preserv-
ative treatment must be verified.
The stored machine must be placed horizontally on a flat and
solid surface,
If the machine is equipped with tyres, it must be stored hori-
zontally on supports so that the clearance between the bearing
surface and tyres is not less than 80 mm (3.15 in).
Access holes, fuel fill holes, exhaust pipes and other holes,
through which atmospheric precipitations can penetrate in
internal cavities of parts of the individual components the ma-
chine, must be sealed hermetically with plugs, stoppers, caps,
using waterproof adhesive tape and/or other special means.
Controls must be adjusted in such positions, in which there is no
danger that the machine starts operating.
If the machine is equipped with a safety cover of the dashboard,
this cover must be secured to prevent the machine from oper-
ating.
If the machine is equipped with a cab, the cab must be locked to
prevent the machine from operating.
The key must not be in the ignition box of the machine and the
battery disconnecter must be in the position “OFF”.
Terminals of the battery must be disconnected. The electrolyte
level must correspond to recommendations of the manufactur-
er.
If the machine is stored for a time interval longer than 2 months,
the batteries must be removed from the machine and stored in
special areas.
Operating fluids of the machine must be refilled up to the levels
specified in this Operating Manual.
A machine stored for a time interval longer than
2 months must be checked regularly according to the
following instructions:
- every 6 months in mild climatic conditions,
- every 3 months in tropical, cold, arctic and seaside
conditions.
Each of the machines, on which the preservative treatment was
carried out, must be provided with instructions for removing
the preservatives.
Instructions for removing the preservatives must specify proce-
dures to remove the preservatives and procedures to reinstall
the dismantled parts of the machine. Besides, a list of tools, in-
struments and devices must be specified, which are required for
performing the working procedures.
The working procedures must contain safety precau-
tions in accordance with relevant national regulations.
2.2 Preservation and storage